Your device and HWID resets

Your account runs on one computer. The first time you run your client, that computer is bound to your account automatically — there is nothing to activate. It stays bound until the binding is released.

When you change computer

If you run a fresh client on a different machine, enrollment is refused and the client shows a device-limit screen with a button to open the website. Freeing the binding is a request, not a button:

  1. Open HWID reset on your dashboard.
  2. Write a short reason — "new motherboard", "old PC died", "sold it" — and send the request.
  3. A person reads it and decides. You'll see the decision on the same tab.

While a request is waiting you cannot send another one; the page shows its state instead of the form. If a request is denied you'll see the reason we gave, and you can send a new one.

After a reset is approved

The binding is released immediately and the old machine is signed out. Go to Client, generate a fresh client, and run it on the new computer — it binds itself to that machine on first launch, the same way the first one did.

Approving a reset does not use up your own reset allowance: an operator made the decision, not you.

Why it works this way

One machine per account is what keeps a single licence a single licence. Making the release an operator decision rather than a self-service button is the part that lets us keep the limit at one without stranding anyone who genuinely changes hardware.

On this page

Are you sure?